</a>LED" title="LED">LED" title="LED">LED照明解決方案的PFC和半橋諧振組合控制器,集成了實現高效率和小型LED驅動器/電源所需的所有功能,包括臨界導通模式(CrM) PFC升壓控制器和內置的600V驅動器的半橋諧振控制器,主要用于高效LED驅動器和電源,電控制齒輪以及照明鎮流器.本文介紹了NCL30051主要特性,方框圖,典型應用電路以及60W評估板NCL30051LEDGEVB指標,電路圖和材料清單(BOM).
NCL30051LEDGEVB:60W 90-265 Vac 35-50 V Constant Current up to 1.5A Isolated LED Driver
The NCL30051 is a combination of PFC and half−bridge resonant controllers optimized for off−line LED lighting solutions. This device integrates all the features needed to implement a highly efficient and small form factor LED Driver/Power Supply. It contains a critical conduction mode (CrM) power factor correction (PFC) boost controller and a half−bridge resonant controller with a built−in 600 V driver. The half−bridge stage operates at a fixed frequency, greatly simplifying the control implementations. The output (current or voltage) regulation is achieved by adjusting the PFC stage output voltage − based on a control signal generated external to the NCL30051.
This device includes an enable input on the PFC feedback pin, open feedback loop protection and PFC overvoltage and undervoltage detectors. Other features included in the NCL30051 are a 600 V startup circuit and an adjustable frequency oscillator with a divide by 2 circuit to assure true symmetric duty ratio. The controllers are properly sequenced, simplifying system design.
NCL30051主要特性:
??Voltage Mode CrM Power Factor Correction Controller
??PFC Open Feedback Loop Protection
??PFC Undervoltage Detector
??PFC Overvoltage Detector
??Half−Bridge Stage with 600 V High Side Gate Drive
??State Machine Ensures Proper Turn−on and Turn−off of Half−Bridge Stage
??Controllers are Properly Sequenced for Fault Free Operation
??Non−Latching Fault Management
??Internal 600 V Startup Circuit
??Wide Temperature Range of −40C to +125C
??This is a Pb−Free Device
NCL30051典型應用:
??High Efficiency LED Drivers and Power Supplies
??Electronic Control Gear
??Lighting Ballasts
圖1.NCL30051功能方框圖
圖2.NCL30051簡化應用方框圖
This is a fully isolated up to 60 W, 90-265 Vac off-line, power factor corrected, constant current LED driver using ON Semiconductor’s new NCL30051 two-stage controller. This controller contains the control circuitry for both a critical conduction mode (CRM) boost power factor corrector (PFC), and a fixed frequency, series resonant half-bridge converter, and is housed in a 16 pin SOIC package. The driver is designed to support strings of LEDs that have a forward voltage ranging from 35-50 V and has a nominal driver current of 1000 mA although the current can be increased to 1500 mA with simple component changes on the board. This specific driver design is tailored to support LEDs such as the Cree XLAMP™ XP-G and XM-L, and OSRAM Golden DRAGON™ Plus that have maximum drive currents of at least 1000 mA. This board has supports a range of flexible dimming options including bi-level, PWM and analog dimming. Details of the demo board are described in evaluation board manual EVBUM2039/D.
圖3.60W NCL30051LEDGEVB評估板外形圖
評估板NCL30051LEDGEVB指標:
Universal Input: 90 − 265 Vac (up to 305 Vac with component changes)
Frequency 47 − 63 Hz
Power Factor: > 0.9 (50−100% of Load with dimming)
Harmonic Content EN61000−3−2 Class C Compliance
Efficiency > 88% at 50 −100% of 50 W, Iout = 1 A / Vf = 50 V
Target UL1310 Class 2 Dry/Damp, isolated < 100 VA and < 60 V peak
Vmax Range: 35 to 50 Vdc (selectable by resistor divider)
Constant Current
Iout Range: 0.7 − 1.5 A, 1 A nominal (selectable by resistor)
Vout Compliance >50 to 100% of Vout
Current Tolerance ?2% or better
Cold Startup < 1 sec typical to 50% of load
Pout Maximum: 60 W
Dimming: Two Step Bi−level Analog Dimming
PWM dimming with optional DIM board
PWM dimming frequency 160 Hz –300 Hz with external signal input (referenced to a secondary side signal ground)
Dimming range > 10:1
0−10 V (100K) analog voltage input dimming, 1 = minimum, 10 V is 100%
on (range dependent on nominal AC input)
Protection: Short Circuit Protection
Open Circuit Protection < 60 V peak
Over Temperature – (optional)
Over Current Protection − Auto recovery
Over voltage protection (input and optional output)
圖4.NCL30051LEDGEVB評估板初級邊電路圖
圖5.NCL30051LEDGEVB評估板次級邊電路圖
圖6.DIM卡電路圖
NCL30051LEDGEVB評估板材料清單(BOM):
詳清請見:
http://www.onsemi.cn/pub_link/Collateral/NCL30051-D.PDF
和
http://www.onsemi.cn/pub_link/Collateral/EVBUM2039-D.PDF
NCL30051LEDGEVB:60W 90-265 Vac 35-50 V Constant Current up to 1.5A Isolated LED Driver
The NCL30051 is a combination of PFC and half−bridge resonant controllers optimized for off−line LED lighting solutions. This device integrates all the features needed to implement a highly efficient and small form factor LED Driver/Power Supply. It contains a critical conduction mode (CrM) power factor correction (PFC) boost controller and a half−bridge resonant controller with a built−in 600 V driver. The half−bridge stage operates at a fixed frequency, greatly simplifying the control implementations. The output (current or voltage) regulation is achieved by adjusting the PFC stage output voltage − based on a control signal generated external to the NCL30051.
This device includes an enable input on the PFC feedback pin, open feedback loop protection and PFC overvoltage and undervoltage detectors. Other features included in the NCL30051 are a 600 V startup circuit and an adjustable frequency oscillator with a divide by 2 circuit to assure true symmetric duty ratio. The controllers are properly sequenced, simplifying system design.
NCL30051主要特性:
??Voltage Mode CrM Power Factor Correction Controller
??PFC Open Feedback Loop Protection
??PFC Undervoltage Detector
??PFC Overvoltage Detector
??Half−Bridge Stage with 600 V High Side Gate Drive
??State Machine Ensures Proper Turn−on and Turn−off of Half−Bridge Stage
??Controllers are Properly Sequenced for Fault Free Operation
??Non−Latching Fault Management
??Internal 600 V Startup Circuit
??Wide Temperature Range of −40C to +125C
??This is a Pb−Free Device
NCL30051典型應用:
??High Efficiency LED Drivers and Power Supplies
??Electronic Control Gear
??Lighting Ballasts
圖1.NCL30051功能方框圖
圖2.NCL30051簡化應用方框圖
This is a fully isolated up to 60 W, 90-265 Vac off-line, power factor corrected, constant current LED driver using ON Semiconductor’s new NCL30051 two-stage controller. This controller contains the control circuitry for both a critical conduction mode (CRM) boost power factor corrector (PFC), and a fixed frequency, series resonant half-bridge converter, and is housed in a 16 pin SOIC package. The driver is designed to support strings of LEDs that have a forward voltage ranging from 35-50 V and has a nominal driver current of 1000 mA although the current can be increased to 1500 mA with simple component changes on the board. This specific driver design is tailored to support LEDs such as the Cree XLAMP™ XP-G and XM-L, and OSRAM Golden DRAGON™ Plus that have maximum drive currents of at least 1000 mA. This board has supports a range of flexible dimming options including bi-level, PWM and analog dimming. Details of the demo board are described in evaluation board manual EVBUM2039/D.
圖3.60W NCL30051LEDGEVB評估板外形圖
評估板NCL30051LEDGEVB指標:
Universal Input: 90 − 265 Vac (up to 305 Vac with component changes)
Frequency 47 − 63 Hz
Power Factor: > 0.9 (50−100% of Load with dimming)
Harmonic Content EN61000−3−2 Class C Compliance
Efficiency > 88% at 50 −100% of 50 W, Iout = 1 A / Vf = 50 V
Target UL1310 Class 2 Dry/Damp, isolated < 100 VA and < 60 V peak
Vmax Range: 35 to 50 Vdc (selectable by resistor divider)
Constant Current
Iout Range: 0.7 − 1.5 A, 1 A nominal (selectable by resistor)
Vout Compliance >50 to 100% of Vout
Current Tolerance ?2% or better
Cold Startup < 1 sec typical to 50% of load
Pout Maximum: 60 W
Dimming: Two Step Bi−level Analog Dimming
PWM dimming with optional DIM board
PWM dimming frequency 160 Hz –300 Hz with external signal input (referenced to a secondary side signal ground)
Dimming range > 10:1
0−10 V (100K) analog voltage input dimming, 1 = minimum, 10 V is 100%
on (range dependent on nominal AC input)
Protection: Short Circuit Protection
Open Circuit Protection < 60 V peak
Over Temperature – (optional)
Over Current Protection − Auto recovery
Over voltage protection (input and optional output)
圖4.NCL30051LEDGEVB評估板初級邊電路圖
圖5.NCL30051LEDGEVB評估板次級邊電路圖
圖6.DIM卡電路圖
NCL30051LEDGEVB評估板材料清單(BOM):
詳清請見:
http://www.onsemi.cn/pub_link/Collateral/NCL30051-D.PDF
和
http://www.onsemi.cn/pub_link/Collateral/EVBUM2039-D.PDF
本站內容除特別聲明的原創文章之外，轉載內容只為傳遞更多信息，并不代表本網站贊同其觀點。轉載的所有的文章、圖片、音/視頻文件等資料的版權歸版權所有權人所有。本站采用的非本站原創文章及圖片等內容無法一一聯系確認版權者。如涉及作品內容、版權和其它問題，請及時通過電子郵件或電話通知我們，以便迅速采取適當措施，避免給雙方造成不必要的經濟損失。聯系電話：010-82306118；郵箱：aet@chinaaet.com。